قطع القطع بنفث الماء

Typical applications

Below is where this material actually ends up — the specific parts, not just the industry. Compare it with your own service conditions, or send us the environment and we will advise.

• Thick shaped parts — flanges and connection plates from 20–80 mm
• Heat-sensitive parts — precision parts that must not distort
• Laminates and stacks — stainless cut together with other materials
• Food and medical equipment — cut faces with no heat-affected zone

Selection FAQ

Waterjet or laser?

Laser for sheet up to about 12 mm and tight tolerance — faster, narrower kerf. Waterjet for thick plate, heat-sensitive parts, and where a heat-affected zone is unacceptable.

How rough is the waterjet cut face?

Typically a matte finish around Ra 3.2–6.3. Slower cutting gives a smoother face at higher cost.